This positioner has a pivot design with screw tilt control, and a 10 inch steel table. This allows heavier loads of approximately 175 pounds, centered in the vertical. This unit has a 2 inch center hole, foot pedal, double sealed twin ball bearings, enclosed gearing, and our unique Dual Constant Current Contact, that is spring loaded for long life, rated at 300 amps @ 75% Duty Cycle. Motor is a 0-10 RPM 90V DC Leeson Electric USA, PM gearmotor and control uses 115V AC power, insulated and isolated for H.F. TIG welding. (See units below for chuck options)

This unit incorporates the same features of the WP-12-NC above PLUS an 8 inch capacity, 3 jaw universal chuck, 10" table and a 10" steel mounting plate, key and one set of reversible hard jaws.

This unit incorporates the same features of the WP-12 above PLUS an 8 inch capacity, 3 jaw SPEED WHEEL Production universal chuck, 10" table and 10" steel mounting plate and one set of reversible hard jaws.